The Scanstrut DS-H10-BLK Horizontal Cable Seal is a black three-pack of low-profile seals for cables from 6 to 10mm.
Three of a horizontal seal suits a single boat rather than an installer’s stock, against the five-pack of the same part. A boat rarely needs more than two or three cable entries on vertical surfaces, so the smaller pack matches the job without leaving spares in a drawer.
Horizontal routing sends the cable out sideways along the surface, which suits an arch leg, a bulkhead or a console face. A vertical seal on the same surface would point the cable straight out into the air, and the run would need supporting immediately.
A tapered gland seals around the cable while a closed-cell foam gasket seals the housing to the mounting surface. Pre-drilled and blank inner seals give flexibility, and the split-seal design passes pre-terminated cables without removing connectors. Explore more cable seals and glands.
- Three-pack for one boat, five-pack for an installer
- Horizontal routes the cable along the surface
- A vertical seal there points the cable into the air
- Two seals: around the cable and under the fitting
